![]() Re-aim external device and try again.Ĭommunication successful, but the command was not valid for this machine type, or the control could not perform the command in its current mode of operation. Re-insert audit card and wait until machine prompts for card removal.Ĭommunication failure. If error persists, replace control or card reader. Power down, power up and try again.Ĭard reader initialized, communication lost. Control will destroy card.Ĭommunication is valid, but there is no card reader initialization. Replace card readerįaulty firmware in reader. Replace card reader.įaulty firmware in reader. If error persists, card may be inoperative.įirmware Update Failed, S/W (Software) Intactįirmware load failed. Download card contents to PC and clear card for re-use. Use a card which does not exceed maximum value.Ĭard memory is full. If error persists, card may be inoperative. Clean chip on card or card reader contacts. Before downloading, ensure data is for current machine type.Ĭommunication failure. ![]() Before downloading, ensure data is for current machine type and recheck the programming option's value and try again. Incorrect machine type or the value in at least one of the programming options is invalid or out of range. Before downloading, ensure data is for current machine type and control is in correct mode. Change sensor.Ĭommunication successful, but the command was not valid for this machine type, or the control could not perform the command in its current mode of operation. Short in temperature sensor circuit wiring. Manually enable IR on control/Re-aim external device and try again. Before downloading, ensure data is for current machine type. Invalid code downloaded from external device to Electronic Control. Re-aim external device and try again.Įxternal device removed before communication complete. Evaluate security procedures.Įxternal device is improperly aimed at infrared communicator (angle or distance). If error persists, tampering may have occurred. Check coin drop area and remove obstructions. Invalid coin pulse or inoperative coin sensor. If door is closed, check for improper wiring or inoperative door switches. Service the service door or coin vault switches.ĭoor is not closed during an active cycle.
0 Comments
Leave a Reply. |